How to Remove Brass Sleeve from Copper Pipe
(how to remove brass sleeve from copper pipe)
Copper pipes can be very reliable and durable, but over time they may develop a brass sleeve or coating that can make it difficult to work on them. This can be frustrating for those who want to maintain their copper plumbing fixtures.
In this article, we will provide step-by-step instructions on how to remove the brass sleeve from a copper pipe without damaging the underlying material.
Materials Needed:
* A wrench
* A pipe cutter
* A utility knife
* Water
Step 1: Remove the Lever Handles
The first thing you need to do is remove the lever handles that are attached to the brass sleeve. These handles are usually located near the ends of the armature, and you will need to use a wrench to disconnect them.
Step 2: Cut the Brass Material
Once you have removed the lever handles, you will need to cut off the brass material that is attached to the pipe. To do this, use a utility knife to carefully cut through the excess brass, being careful not to damage the rest of the pipe.
Step 3: Apply Clean Water
After cutting off the brass material, you will need to apply clean water to the exposed area of the pipe. This will help to loosen any remaining debris or corrosion.
Step 4: Use a Steel Chisel to Pry Off the Friction Plate
Using a steel chisel, pry off the friction plate that is attached to the brass sleeve. The friction plate helps to keep the spring-loaded lock in place, so removing it will allow you to open the brass sleeve.
Step 5: Remove the Spring-Loaded Lock
With the friction plate removed, you should now be able to remove the spring-loaded lock that holds the brass sleeve closed. Use a wrench to turn the lock counterclockwise until it slides off the brass sleeve.
Step 6: Clean the
Finally, be sure to clean the thoroughly before reinstalling the brass sleeve. Use a mixture of water and vinegar or baking soda to clean the surface of the pipe, then dry it with a clean cloth.
Conclusion
(how to remove brass sleeve from copper pipe)
Removing the brass sleeve from a copper pipe can be a straightforward process if you follow these steps carefully. With a little bit of patience and attention to detail, you can avoid damaging the underlying material and enjoy your newly cleaned copper plumbing fixture. Remember to always wear protective gear when working on copper pipes to prevent injury.
